BANARTA
BSA-16 Studded EPS Heating Panel
The BSA-16 panel combines an expanded polystyrene insulation base with a HIPS surface film. Its mushroom-shaped studs provide a layout for hydronic heating pipes, and four-sided interlocking edges connect neighboring panels.
The published panel size is 1370 × 820 mm, with a total thickness of 40 mm and a 20 mm insulation layer. Use both thickness measurements when planning the floor assembly: the insulation layer is not the full height of the studded panel.
Published Specifications
Description | BSA-16 |
Thermal Conductivity at 10℃ | 0.028W/(m.k) |
Heat Resistance | 0.8(m2.k)W |
Total Thickness | 40mm |
Compressive Strength | About 250KPA |
Size(L*W)in mm | 1370mm*820mm |
Thickness of Insulation Layer | 20mm |
Weight/M2 | 1050g |
Standard Package | 11.2M2 |
Confirm current dimensions, pipe compatibility and test documentation for the supplied configuration before specifying this panel. The model name alone should not be used to select a pipe diameter.
Ordering and Layout Checks
- Provide the heating pipe outside diameter and planned circuit spacing so that the stud layout can be checked.
- Check usable coverage and edge connections when calculating the quantity for each room.
- Confirm the substrate, covering layer and finished floor height with your system designer or installer.
- Request the applicable product datasheet when assessing thermal and load requirements.
For a quotation, include the BSA-16 model reference, required area, pipe specification and delivery destination. Confirm the floor assembly rather than relying on the panel alone to determine finished-floor performance.
Installation Overview
Watch the EPS underfloor heating panel installation video. Request installation instructions for the exact panel and floor system supplied.
Compare dimensions with the BEA-20 EPS underfloor heating panel when reviewing other studded panel options.